Teledyne LeCroy ArbStudio - Manual (Page 159)

Operator’s Manual
922244-00 Rev A 151
B
Creating a Sequence of Waveforms
To create your first Sequence of Waveforms, you must first create a
workspace with Arbitrary Waveform Generator as the Operating Mode and
at least one Analog Channel. See steps 5 and 6 in Arbitrary Waveform
Generator Setup Example (on page 27) for details. If you already have a
workspace open, be sure it meets the aforementioned requirements
before proceeding with the following steps:
1. Double-click the Waveform Sequencer under Channel 1 (Arbitrary)
on the Device Control Tree. (Channel 1 can be any Analog channel
you have configured under Arbitrary Waveform Generator operating
mode in your workspace.)
The Waveform Sequencer is then shown.
2. Now, we'll add three waveforms to our Project Waveforms. Do this
by pressing the Add Standard Waveform button and providing the
following specifications for waveforms 1, 2, and 3 on the Waveform
Standard Editor dialog box each time.
The Add Standard Waveform Button