Teledyne LeCroy ArbStudio - Manual (Page 164)

ArbStudio
156 922244-00 Rev A
3. The Waveform Standard Editor dialog box is shown.
In the fields on the Editor, select a Sine waveform Type, 1 MHz
Frequency, 250 Samples, and 1 Volt Amplitude.
Click OK.
NOTE : The aforementioned steps create our Carrier Waveform.
4. On the Project Waveforms tab under the Waveform Sequencer,
select the Carrier Waveform we just created and click the Add
Waveform button (adding it to the Sequencer).
5. Double-click Modulation Editor under Channel 1 (Arbitrary) on the
Device Control Tree. (Channel 1 can be any Analog channel you have
configured under Arbitrary Waveform Generator operating mode in
your workspace.)