Opening an existing workspace – Teledyne LeCroy ArbStudio User Manual
Page 34
ArbStudio
26
922244-00 Rev A
6. Click Next. The wizard Finish screen is shown.
7. Click Finish.
NOTE: If your workspace contains additional ArbStudio devices, the
wizard does not show this Finish screen. Instead, the wizard repeats
itself to configure additional devices until all attached workspace
devices are setup properly.
When a workspace has been created or edited, the ArbStudio environment
becomes active and the workspace name is shown in the ArbStudio
window header.
Opening an Existing Workspace
1. Click the
Open Workspace toolbar button.
The Open Workspace screen appears, displaying the AWGProjects
folder.
2. Select the desired workspace and click Open.
NOTE: Every workspace is associated with the serial number of a
connected ArbStudio instrument.
3. If a Serial ID for a previously connected ArbStudio instrument in your
workspace is different from ones currently connected, the Relink
Project Devices screen is shown:
Make new assignments using the Connected Device drop-down and
click OK.