Teledyne LeCroy ArbStudio - Manual (Page 144)

ArbStudio
136 922244-00 Rev A

HiZ - Search for a High Impedance (only for Pattern Generator
Mode).

Rise - Searches for a Rising Edge trigger.

Fall - Searches for a Falling Edge trigger.

Change - Searches for any trigger edge.
The From Start button can be used to specify where the search starts
within your data acquisition. Possible options include:

From Start - Starts the search from the beginning of the acquisition.

From End - Starts the search from the end of the acquisition.

From Trigger - Starts the search from the trigger position.

Master Marker - Starts the search from the Master Marker position.
Select criteria on the Search Settings screen and click the OK button. The
results are then shown on the State Listing or Waveform View screen
(depending on where you started your search).
Use the Search Backward or Search Forward buttons to navigate through
your search results.
NOTE: As you navigate through your search results, the master cursor is
updated to the subsequent values in your results.