Teledyne LeCroy ArbStudio - Manual (Page 89)

Operator’s Manual
922244-00 Rev A 81
B
In the Signal Type search list on the right side of the Search Settings
window, all defined signals and busses are shown. Select the signal or bus
and then provide a specific value for the search.
NOTE: Depending on the Signal Type selected in the search list, the
Compare and Value fields contains different options.
Use the Compare field to select between the following search logic
operators:

= - Find the equivalent value.

!= - Find the unequal value.

> - Find values greater than the one specified (only available if a bus
is selected).

< - Find values less than the one specified (only available if a bus is
selected).

HiZ - Find high impedance values.
Use the Value field to provide the specific value or edge on which to
search. If one Signal Type is selected, the Value field has the following
options:

0 - Searches for a logic 0.

1 - Searches for a logic 1.

HiZ - Search for a High Impedance (only for Pattern Generator
Mode).