Teledyne LeCroy ArbStudio - Manual (Page 182)

ArbStudio
174 922244-00 Rev A
6. On the The DEV1 Settings Ch 1 pop-up screen's Run Mode tab,
select Single and press OK.
When the instrument starts, the Single Run Mode repeats
Waveform1 until you press the Force Stop button.
7. Now, press the Run/Stop button on the ARBStudio toolbar.
The software loads the settings and the waveforms into the
ArbStudio 1102/1104 instrument and starts generating the
waveforms.
8. Waveform1 is generated on the CH1 BNC output. You can connect
an oscilloscope to this output and analyze the signal.
9. Stop generating waveforms by pressing the Run/Stop button again
or the Force Stop button (also on the ARBStudio toolbar).