Teledyne LeCroy ArbStudio - Manual (Page 160)

ArbStudio
152 922244-00 Rev A
The Waveform Standard Editor Dialog Box

Waveform 1 - Sine waveform Type, 1 MHz Frequency, 250 Samples,
and 1 Volt Amplitude. Click OK when finished, and then repeat by
clicking the Add Standard Waveform button on the Waveform
Sequencer.

Waveform 2 - Triangle waveform Type, 2 MHz Frequency, 250
Samples, and 1 Volt Amplitude. Click OK when finished, and then
repeat by clicking the Add Standard Waveform button on the
Waveform Sequencer.

Waveform 3 - Rectangle waveform Type, 4 MHz Frequency, 250
Samples, and 1 Volt Amplitude. Click OK when finished.
3. On the Project Waveforms tab under the Waveform Sequencer,
select the waveform you just created and click the Add All
Waveforms button (adding all of your new waveforms to the
Sequencer).
4. Double-click Settings under Channel 1 (Arbitrary) on the Device
Control Tree. (Channel 1 can be any Analog channel you have