Source connector, Edge, Action – Teledyne LeCroy ArbStudio User Manual
Page 49
Operator’s Manual
922244-00 Rev A
41
B
Source Connector
Use this field to select the physical source for a Trigger In event. Choose
one of the following as explained.
BNC Trigger IN - The trigger event is received by the dedicated BNC
Connector on the instrument front panel.
Pod A Trigger IN - The trigger event is received by a dedicated Digital
input of the probe connected to the Pod A in the instrument front
panel - see Probe Description.
NOTE: Trigger IN source setting is mutually exclusive.
Edge
You can set the sensitive edge for the input trigger as Rising or Falling
Edges.
Action
You can set the action for ArbStudio to perform when there is an input
Trigger event. The possible options include:
A Start command being generated at any event.
A Stop command being generated at any event.