Creating a frequency modulated waveform, Operator’s manual – Teledyne LeCroy ArbStudio User Manual
Page 169
Operator’s Manual
922244-00 Rev A
161
B
Creating a Frequency Modulated Waveform
Create a Frequency Modulated Waveform by first creating a workspace
with Arbitrary Waveform Generator as the Operating Mode and at least
one DDS Channel. See steps 2, 5, and 6 in Arbitrary Waveform Generator
Setup Example (on page 27) for details (and be sure to select DDS instead
of Arbitrary during step 2). If you already have a workspace open, be sure it
meets the aforementioned requirements before proceeding with the
following steps:
1. Double-click the Carrier Editor under Channel 1 (DDS) on the Device
Control Tree. (Channel 1 can be any DDS channel you have
configured under Arbitrary Waveform Generator operating mode in
your workspace.)
2. The default Component 1 Carrier settings are shown on the
Component Definition dialog. These default settings include a Sine
wave Type with a Length of 2048 samples, Amplitude of 1 V, and 1
Cycle. You can modify Component 1 of the Carrier as desired.