Teledyne LeCroy ArbStudio User Manual
Page 72
ArbStudio
64
922244-00 Rev A
frequency 200 kHz, duration 100 µs) amplitude-modulated with a period of
sine signal. The following steps demonstrate the procedure.
1. Click the Add Advanced Waveform button to open the Waveform
Editor dialog box.
2. Select Component1 of Segment1, choose sine wave in the
component type, set its length to 100 µs, and 1 cycle in the
Parameters window. Now, set the amplitude to 5 V.
3. Now, in the Waveform Manager area, right click on Waveform1 and
select Add Segment.
4. Select Add on the Component Operation drop-down field.
5. Select Segment1 and then click the Add Segment/Component
button in the Waveform Manager to add a new component.
6. In the Type field, select Rectangle, Frequency 200 kHz (or select 20
cycles from the first two parameters drop-down fields), Time 100 µs,
amplitude to 1 V, and duty cycle to 50%.
7. Set the segment amplitude (1 V) and duty cycle (50%).
8. Now select Multiply on the Component Operation drop-down and
click the OK button.
9. Click Waveform1 and the desired waveform is shown in the
Waveform Editor window.