The waveform sequencer - analog, Creating standard and advanced waveforms, Creating a standard waveform – Teledyne LeCroy ArbStudio User Manual
Page 59
Advertising
Operator’s Manual
922244-00 Rev A
51
B
The Waveform Sequencer - Analog
Creating Standard and Advanced Waveforms
Creating a Standard Waveform
Create a new waveform in the Waveform Sequencer using the following
steps.
Press the Add Standard Waveform button.
The Waveform Standard Editor dialog box is shown.
Provide a Name for your waveform.
Use the Type drop-down and select DC Level, Sine, Increase Ramp,
Sawtooth, Rectangle, or Triangle.
Use fields on the Timing section to set Length, Frequency, and Cycle
parameters.
Fields on the Parameters section can be used to set Amplitude,
Offset, Phase, Maximum and Minimum Voltage levels
Click the OK button to create the waveform and add it to the
project.
Advertising