Agilent Technologies N2610A - Manual (Page 114)

106 Agilent FrameScope 350 User’s Manual
4 Fiber Testing
Setting Up an Autotest
Choosing the Network Limit
The FrameScope 350 can certify cabling for compliance with the
physical medium dependent (PMD) requirements of popular
network interface technologies such as Ethernet or ATM.
Network certification can be performed in addition to certifying
to cabling limits.
A pass result for a particular networking technology indicates
that the tested cable run meets the loss and length requirements
necessary to successfully support communications between
devices of that type.
To choose the network limit:
1 On the Fiber Autotest Settings screen, press Network Limits, then
press Edit. The Networks Setup screen displays.
2 Press a limit to choose it. When you have placed check marks next to
all types of networks you wish to certify, press OK. The Fiber
Autotest Settings screen displays.
Entering the Site Name
The site name identifies the group of settings used on a job.