Agilent Technologies N2610A - Manual (Page 152)

144 Agilent FrameScope 350 User’s Manual
5 Cable Testing in Expert Mode
Running COAX and TWINAX Autotests
cable is automatically selected. Press the Edit Settings button to
change any settings.
I‚‡r) UurÃA h€rTp‚ƒrÃ"$Ãq‚r†Г‚‡Г†ƒrpvs’Гh’Гr‡‚ xvtƇhqh q†Ã‡uh‡Г ˆГ‚ГUvh‘Ã
phiyrÃ6’Ãh‡‡r€ƒ‡Г‡‚Г ˆГhГ8r ‡vs’ÃIr‡‚ x†Ã‡r†‡Ã‚ÃhÃUvh‘ÃphiyrÐvyyÇ vttr ÃhГr ‚ Г
€r††htrƇh‡vtÇuh‡Ã‚rÂsÇurÁr‡‚ x†Ã†ryrp‡rqÃh rÃp‚svtˆ rqГ‡‚Г ˆГ‚Г‡uv†Ã‡’ƒrÂsÃ
phiyr
2 Press the Start Test button from the Autotest Setup screen to
perform the Twinax Autotest
Results
The Twinax Autotest evaluates length and cable integrity.
Twinax cable integrity includes the detection of a properly
connected shield. These results are shown in both the diagram
at the top of the screen and the table at the bottom. Delay and
NVP information are also shown. Pressing the Details button
shows more information about the test.