Agilent Technologies 85225F - Manual (Page 108)

108 Installation and User’s Guide
4 Servicing the System
To package the system for transport
Follow these instruction to package the system in a shipping crate.
To package the system for transport
Step Note
1 Place the packaging base in an
unobstructed work area.
2 Remove the lag bolt from one side
of the retaining piece.
3 Swing unbolted end of retaining
piece outward.
4 Attach loading ramp.
5 Roll rack cabinet up ramp face first
until it is fully seated on base.
6 Remove ramp.
7 Swing retaining piece back to
original position.
8 Secure retaining piece with bolt.
9 Secure rack cabinet to base using
retaining brackets inserted in the
slot located on each side of the
packaging base.
10 Secure retaining brackets with bolt
and tighten.
11 Place antistatic bag over rack
cabinet.
12 Place cardboard/foam top cap on
top of rack cabinet.
13 Place folded ramp on top cap.
14 Place crate side panel and crate
front panel on to base (the side
panel, with wooden cleat, goes on
the outside of the front panel).
15 Connect both panels by hammering
klimps approximately every two
feet along the vertex.
16 Place the lid in position and attach
to all side panels and front panel
using klimps.