Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 123)

GPS Reference Manual
28
Note: When this screen is used by the RTK rover for updates of
antenna height during a survey, the Set button will send the new
antenna parameters to the receiver as well as updating Survey Pro's
settings.
Rover Setup
6XUYH\ 5RYHU 6HWXS 
The Rover Setup screen is used to configure an RTK rover to begin
receiving differential corrections and to start the survey with the base
reference position.
Rover Status : displays the status of the rover.
Base set at : displays the current base point.
This will be empty if the base is not set.
Lat : displays the latitude of the base.
Long : displays the longitude of the base.
Height : displays the ellipsoid height of the
base.
*(7 IURP %DVH : is used when the GPS base
position is not known to this data collector.
This function will get the base station’s geodetic coordinate over the
radio link and set the base position in Survey Pro. It will then
configure the rover receiver to start receiving differential corrections.
6(7 5RYHU : is used when the base station was set with this data
collector. This function configures the rover with the displayed
geodetic coordinate.
Last Antenna for this Receiver : displays antenna information defined
from the Rover Receiver Antenna screen, opened from
6HWXS +5. The
title of this field changes depending on if the antenna has already
been setup.