Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 51)

RTK Data Collection
47
• Delta N and E are the translations between the desired local start
coordinate and the origin of the TDS Localization map projection
(100000, 100000) m.
5. Tap
$FFHSW. You are now ready to start data collection.
Localization Calculator
Note: The Localization calculator is used to provide the field
procedure for a workflow supported in Survey Pro versions prior to
3.5. This routine is similar to a one-point Localization, except that
rotation is calculated parallel to a selected map projection. The
easiest way to start a ground survey is with the one point
Localization procedure described above.
1. After choosing the projection settings and configuring the base
and rover receivers, go to Projection from the Survey menu
2. Tap
6ROYH /RFDOL]DWLRQ« to open the Solve Localization wizard and
then tap
&DOFXODWRU!.
Note: The vertical card will be the vertical manual parameter screen
described in the previous section.
3. Leave the scale at 1.0. For an explanation of the scale factor or to
review the reference height used for ground scale, tap the
&DOF
6FDOH button.
4. Calculate the rotation for this setup. Tap
&DOF 5RWDWLRQ to open
the Localization Calculator. If you have not already selected a
mapping plane, you will be prompted to do so now.
5. Tap
6ROYH 5RWDWLRQ! to calculate rotation for the localization
origin in the selected map projection zone.