Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 41)

RTK Data Collection
37
Note: If you select a point from the job’s control file, you will be
prompted to make a local copy of the point. Control point collection
will add a geodetic coordinate to the point record and points in the
job’s control file cannot be modified.
Note: If Store GPS Raw Data on the Measure Mode card of the Job,
Settings screen is set to EP + Rx Raw (or + OBN for Ashtech users),
when you begin a point occupation the control point name is checked
as a valid site ID for the receiver. If it is not a valid site ID, we will
use a modified point name in the receiver’s internal file and make a
note of the modified name in the job’s .RAW file. The point name in
Survey Pro is not changed.
3. Occupy the point and tap
&RQWURO 3RLQW to begin data collection.
4. When you are happy with the measurement, tap
$FFHSW.
5. Check the Results tab for details of the previous measurement.
Check the Map tab to see the number and position of control
points for this set up group.
6. Collect a minimum of 2 control points to solve horizontal
localization. Collect a minimum of three vertical control points to
solve vertical localization. Collect one vertical control point to
solve just the localization vertical shift when using a geoid model.
7. When you have collected the minimum number of control points,
tap
3URMHFWLRQ to open the Projection screen.