Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 180)

Stakeout Menu
85
Note: When Store GPS Raw Data on the Job/ Settings/ Measure Mode
card (Page R-8) is set to + Rx. Raw ( and / or +OBN for Ashtech)
switching from ROVING to OCCUPYING will start a session in the
receiver, so you will be prompted for a point name and description.
The receiver session will be completed and the measurement stored
when you tap
6WRUH. The occupation is not stored in the Survey Pro
.RAW file if you toggle back to ROVING.
5HVXOWV / 1(= : displays either the results, or plane coordinates
in the lower corner of the screen.
Station : is the station at the current rod position.
Offset Dist : is the perpendicular distance from the line to the rod.
Elev : is the elevation at the rod position.
Offset : displays if the rod is on the Left or Right of the line.
Segment : displays the type of line segment at the current station.
%DFN: returns to the previous screen.
6WRUH : stores a point for the current rod location.
Store Offset Points
6WDNHRXW 6WRUH 2IIVHW 3RLQWV 
The instructions for the Store Offset Points routine for GPS are
similar to the conventional method, except that the
%DFNVLJKW button
is replaced with a
6HWXS +5 button to configure rover antenna and
the backsight information is replaced with rover antenna height
information. See the conventional Reference Manual for details.