Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 37)

RTK Data Collection
33
Rover Receiver Setup
Use the Rover Setup screen to configure a GPS receiver to be an RTK
rover.
1. Go to Rover Setup from the Survey menu.
Rover setup procedure depends on how the base was set. If the base
was set with this data collector, the base reference position is already
known in Survey Pro and you can simply SET the rover to start your
survey. If the base was set with a different data collector, you need to
GET the base reference position from the radio link to configure the
base coordinate in Survey Pro and start your RTK survey.
SET Rover with Known Base Position
2. Tap
6HWXS +5 to select your antenna type and measure the slant
or vertical height of the antenna.
Note: If this receiver has already set an antenna with Survey Pro,
the measurement and settings will be recalled from the registry, so
you will not have to do this step again.
3. Tap
6(7 5RYHU to configure the receiver and begin receiving RTK
base information over the radio link.
Note: If you have post processing data collection turned on, the
receiver will now open a file (with the next available default name),
start recording GPS raw data, and enter the antenna information for
this setup.
4. You will return to the Survey menu when this is complete.
GET Base Position from Radio Link
a. Tap
6HWXS +5 to select your antenna type and measure the slant
or vertical height of the antenna.
b. Tap
*(7 IURP %DVH to configure the receiver and begin receiving
RTK base information over the radio link.