Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 127)

GPS Reference Manual
32
Occupy Control Point Screen
6XUYH\ &RQWURO 3RLQWV &RQWURO 3RLQW 
The Occupy Control Point screen is used to add geodetic coordinates
for a known project point. The most common use of this screen is to
measure control points for the localization solution. This screen is
also used by the Localization Calculator routine (Page R-51) for one
point localization setup.
Geodetic Coordinates : displays the geodetic
coordinates measured to the current control
point.
Epochs : displays the number of epochs
recorded since the beginning of data collection.
Count Status : displays Measuring when we are
receiving fresh coordinates from the receiver
and updating the screen with the latest
measurement.
Averaging is displayed after you
tap
$FFHSW while we average the number of
epochs specified in the Epochs to Average on Accept field on the
Measure Mode Settings screen (if this value is greater than 1).
Suspended is displayed if we are not receiving valid data from the
receiver or while you are viewing a separate screen (like GPS Status).
Solution Quality : displays the quality of the current measurement:
the solution type, the number of satellites used, and the horizontal
and vertical precision computed by the receiver.
Control Point : is where you select if the current point is to be used for
Horizontal control and/or Vertical control by tapping the appropriate
checkboxes.
$FFHSW : accepts the current control point and returns you to the
Control Points screen.
*36 6WDWXV : stops the epoch counter and opens the GPS Status
screen (Page R-20).