Fire-Lite 411UDAC Fire Alarm Communicator - Manual (Page 32)

32 411UDAC Manual — P/N 51073:E 9/20/2013
Modes of Operation Password Creation and Entry
1st EVENT KEY
This key, along with the UP and DOWN arrow keys, are used only in Program Mode. Press the 1st
EVENT key at any time to display the first program memory address and its content. The follow-
ing may be displayed on the Programmer:
If the 1st EVENT key is pressed a second time, the following will be displayed on the Programmer
display:
The contents of any address can be viewed by entering the digits of the desired address. For exam-
ple, to view the contents of address 86, press the '8' key on the keypad. '8' will appear as the first
digit in the display, a blank will appear in the position of the second digit and the decimal point will
move one position to the right, indicating that the next digit can now be entered.
Press the '6' key on the keypad. '6' will appear as the second digit on the display and the decimal
point will move one position to the right. Press the [ENTER/STORE] to view the contents of
address 86.
DOWN ARROW
Use the DOWN arrow key to decrement the memory address and view its content.
UP ARROW
Use the UP arrow key to increment the memory address and view its content.
ENTER/STORE
Stores entry into nonvolatile E
2
memory located on the 411UDAC printed circuit board, then incre-
ments to the next higher address.
3.1.2 Programmer Display
Four 7-segment red LED characters provide visual display of information in the various modes of
operation.
3.2 Password Creation and Entry
In order to access the Default Mode or Programming Mode, a valid password must be entered.
1. Press the MODE key followed by the 4-digit entry code (3337 for Default Mode or 7764 for
Program Mode).
2. Press the [ENTER/STORE] key. The display will read LinP indicating that a valid password
is required to continue.
00_F
(address) (data)
0.
Digit to be programmed
8_.
Digit to be programmed
86_.