Fire-Lite 411UDAC Fire Alarm Communicator - Manual (Page 33)

411UDAC Manual — P/N 51073:E 9/20/2013 33
Real Time Clock Mode Modes of Operation
3. For the initial power-up of the 411UDAC or for the first power-up after a manually defaulted
password, key in the default password 0000 and press [ENTER/STORE]. The display will
then read dC_P.
4. Press d to continue with the default password or press C to change to a new password.
5. If d is entered in step 4, the display goes directly to the programming/default modes.
6. If C is entered in step 4, the display will read En_P prompting for a new password.
• Key in a new 4-digit password. Valid passwords are any four digit code from 0001-9999.
• The display will then read rEnP. Key in the new password again for verification.
• Once the new password has been verified, the programming/default modes will be accessed.
If at any time a password was entered incorrectly, the display will read AErr indicating an invalid
entry was made.
3.3 Real Time Clock Mode
Real Time Clock Mode is entered by pressing the MODE key followed by the 4-digit entry code
2525 and pressing the [ENTER/STORE] key. Accessing this mode requires authentication. Refer
to Section 3.2.
– 2525 spells CLCK on a Touch-Tone
®
phone.
If an incorrect key is entered, reenter the proper 4-digit code before pressing the
[ENTER/STORE] key. Note that as information is entered into the 411UDAC, the digits will
scroll across the Programmer display from right to left.
___2
__25
_252
2525
A pause of up to 10 seconds between each number is allowed while entering the code. After press-
ing the [ENTER/STORE] key, the 411UDAC will be in Real Time Clock Mode. A maximum of
10 minutes idle time is allowed at this point before beginning program entries and between each
key stroke, otherwise, the 411UDAC will return to Normal Mode. Note that the time is not stored
until the fourth and final digit is selected and the [ENTER/STORE] key is pressed. If the
411UDAC returns to Normal Mode prior to entering the fourth digit, no changes will be stored and
the original time is retained.
On entering Real Time Clock Mode, 0.001 will appear on the Programmer display:
The time is displayed in military time. Note the position of the decimal point in the display. This
indicates that the first digit to be programmed is the one to the left of the decimal point. To pro-
gram the first hour digit, press the corresponding number on the Programmer keypad and then press
the [ENTER/STORE] key. For example, to program 2:00 PM (1400 in military time), press '1' on
the keypad and then the [ENTER/STORE] key. The number '1' will appear as the far left digit and
the decimal point will move one position to the right indicating that the second digit from the left is
now ready for programming.
0.001
Digit to be programmed
10.01
Digit to be programmed