West Control Solutions Pro-EC44 - Manual (Page 68)

Pro-EC44 2-Loop Graphical Profile Controller & Recorder
Pro-EC44 Product Manual - 59540-1 October 2013 Page 61
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
 USB MENU SCREENS
USB Mode Unlocking Enter correct code number to access the USB Menu.
Factory Default value is 10.
Read/Write To USB
Device Select the required action from: Read Configuration File; Write
Configuration File; Write Recorder Log File. Read Profile Files; Write Profile
Files.
Note:
“Writing” is downloading from the Instrument to the USB
stick. “Reading” is uploading from the USB stick to the
Instrument.
Wr
it
e
Select Profile To
Write If writing a profile to the USB memory stick, choose a profile to write from
the list provided.
Enter A File Name Enter an 8-character file name if writing configurations or profiles. A file
extension is automatically added to the end of file name (bct for
configurations or pfl for profiles).
Caution: Existing files with the same name will be over-written.
Enter A Folder
Name Recorder logs can contain multiple files. The user enters an 8-character
folder name for these logs. See the Data Recorder section on page 97.
Note: To prevent existing recordings being over-written, an error
message is shown if the folder name entered already exists.
Writing Profile,
Configuration or
Log An animated screen is shown the files are being written.
Caution: Do not disconnect USB device until completed! Data loss or
corruption may result.
Transfer
Successful Confirmation that the data transfer to the USB stick completed correctly.
Press R to continue
Transfer Failure For write failures, check for adequate disk space on the USB stick.
R
ea
d
Select File Select the Configuration or Profile file to transfer from the USB stick.
Caution: Configuration reads overwrite all of the instruments existing
settings with new values.
Reading Profile or
Configuration File An animated screen is shown while files are being read.
Caution: Do not remove the memory stick whist this operation is in
progress. Data corruption may result.
Transfer
Successful Confirmation that the data transfer from the USB stick completed correctly.
Press R to continue.
Transfer Failure For read failures, check the maximum number of profiles and/or segments
is not being exceeded.
Note: During Data Transfer, normal operation carries on in the background, but
operator access to other screens is not possible. The transfer of a full memory
can take up to 20 minutes. Only begin a transfer when you are certain that
access (e.g. setpoint changes) will not be required.