Airedale SmartCool 11-233kW - Manual (Page 6)

Health and Safety
IMPORTANT
The information contained in this manual is critical to the correct operation of the unit and should be read by all persons
responsible for the installation, commissioning and maintenance of the Airedale unit.
Safety
The equipment has been designed and manufactured to meet international safety standards but, like any mechanical/
electrical equipment, care must be taken if you are to obtain the best results.
CAUTION
• Installation, service and maintenance of Airedale equipment should only be carried out by technically trained
competent personnel.
• When working with any air conditioning units, ensure that the electrical isolator is switched off prior to servicing or
repair work and that there is no power to any part of the equipment.
• Also ensure that there are no other power feeds to the unit such as fire alarm circuits, BMS circuits etc.
• Electrical installation commissioning and maintenance work on this equipment should be undertaken by competent
and trained personnel in accordance with local relevant standards and codes of practice.
• A full hazard data sheet in accordance with COSHH regulations is available should this be required.
Personal Protective Equipment
Airedale recommends that personal protective equipment is used whilst installing, maintaining and commissioning
equipment.
Manual Handling
Some operations when commissioning, servicing or maintaining the unit may require additional assistance with regard
to manual handling. This requirement is down to the discretion of the engineer. Remember, do not perform a lift that
exceeds your ability.
Environmental Policy
It is our policy to:
• Take a proactive approach to resolve environmental issues and ensure compliance with regulatory requirements
• Train personnel in sound environmental practices
• Pursue opportunities to conserve resources, prevent pollution and eliminate waste
• Manufacture products in a responsible manner with minimum impact on the environment
• Reduce our use of chemicals and minimise their release to the environment
• Measure, control and verify environmental performance through internal and external audits
• Continually improve our environmental performance
CE Directive
Airedale certify that the equipment detailed in this manual conforms with the following EC Directives:
Electromagnetic Compatibility Directive (EMC) 2004/108/EC
Low Voltage Directive (LVD) 2006/95/EC
Machinery Directive (MD) 89/392/EEC in the version 2006/427/EC
Pressure Equipment Directive (PED) 97/23/EC
To comply with these directives appropriate national & harmonised standards have been applied.
These are listed on the Declaration of Conformity, supplied with each product.
SmartCool™ 6 - 200kW Precision Air Conditioning
6
Introduction
SmartCool 6 - 200kW Chilled Water Technical Manual 7674716 V1.1.0_04_2014