Canon VB-C60 - Manual (Page 129)

4-49
Set Motion Detection Recording
R
e
gi
ste
r C
a
m
e
ra
Se
rv
er
and
Set
R
e
co
rdi
ng
Sche
du
le
Step 3: Set the active region for recording
In the [Active Region] field, adjust the region where motion detection is triggered. By default, the [Active
Region] is the full area. In addition you cannot use pan, tilt, and zoom operations in this window.
1. Click one of the corner or edge handles and hold down the mouse button.
2. Drag the handle to change the motion-trigger boundary (dotted frame).
The [Motion Detection Options] field also allows you to set the sensitivity for Motion Detection within the [Active
Region]. [Sensitivity] and [Area Ratio] are selected by using the two sliding bars.
Motion detection status can be confirmed by the [Detection Indicator] during operation.
[Detection Indicator] Colors
Motion is displayed in the [Detection Indicator] as a green color bar and will remain green if the level of motion
is below the configured [Sensitivity] and within a defined [Area Ratio]. If motion reaches the set [Sensitivity]
and [Area Ratio], the color bar changes to yellow and if the detected motion remains at the yellow level for the
specified duration period, a red color bar is displayed and an event is triggered. The behavior of the [Detection
Indicator] is described as follows.
• Green color bar - Changed area is less than the specified [Area Ratio], i.e., activity remains at the left
of the [Area Ratio] marker.
[Area Ratio] marker.
[Area Ratio] slide bar.
[Area Ratio] marker.