Canon VB-C60 - Manual (Page 137)

4-57
Set Sensor Event Recording
R
e
gi
ste
r C
a
m
e
ra
Se
rv
er
and
Set
R
e
co
rdi
ng
Sche
du
le
3. [Record for __ sec. after event] - enter a number of seconds for the amount of recording time after the event
has transpired (up to a maximum of 999 seconds).
Click [OK] to save the new settings and close the dialog.
Click [Cancel] to discard the new settings.
Step 7: Set the External Outputs
1. Click [External Outputs Setting] to control any external devices that may be connected to your Camera
Server.
2. Click [Setup] to change the details of external outputs. Otherwise the default settings will be applied.
3. If [Setup] is clicked, click the drop-down menu for the target external device and set [External Outputs] to
[On] or [Not specified] on the [External Outputs Setting] dialog.
Priorities of Motion Detection and Sensor Event Recordings
You can specify events priorities for the Motion Detection and Sensor Event recordings, and if the events occur
simultaneously, the recording with the higher priority is performed first.
When using the Motion Detection and Sensor Event recordings together and motion detection and sensor input
occur simultaneously, the Sensor Event recording takes precedence.
If two events with the same priority occur, the earlier event takes precedence. When the earlier event
terminates and the later event still remains, the later event will be handled.
Note
z If the [Record for __ sec. before event] or [Record for __ sec. after event] event fields are set to 0
seconds, video will still be recorded while the sensor is activated.
z Longer pre-event recording will increase memory usage. Longer pre-event recording with insufficient
memory may greatly reduce performance when the disk-based virtual memory runs short.
Note
Available external outputs depend on the Camera Server.