Canon VB-C60 - Manual (Page 273)

9-31
Messages List
T
rou
b
les
ho
oti
n
g
Error Codes in Log File
Winsock Error Codes
Codes Error Messages Description
10038
An operation was attempted on something that
is not a socket. This may be recorded in Version 1.1, however,
there is no necessary action.
10048
Only one usage of each socket address
(protocol/network address/port) is normally
permitted.
All resources for communication are being
used. This frequently occurs when a black
screen problem occurs in Viewer layout
sequences.
10050
A socket operation encountered a dead
network.
This occurs when the PC recognizes that the
network is not available because the closest
router or Hub to the PC is powered off.
Normally, this cannot be recognized, therefore
it is rare that this error is reported.
10051
A socket operation was attempted to an
unreachable network.
This occurs when another network device
recognizes that the network is not available
because the router or Hub is powered off.
Normally, this cannot be recognized, therefore
it is rare that this error is reported.
10054
An existing connection was forcibly closed by
the remote host.
The connection is disconnected by the camera
server due to camera server restart or other
cause. This may occur when the camera
server is restarted using the restart button on
the configuration page on the software-side.
However, this rarely occurs.
10060
A connection attempt failed because the
connected party did not properly respond after
a period of time, or established connection
failed because connected host has failed to
respond.
A timeout occurred in the TCP connection with
the camera server (This occurs when the
camera server is down).
10061
No connection could be made because the
target machine actively refused it.
The camera server rejected the TCP
connection (This occurs when the port number
specification is incorrect or other cause).
10064
A socket operation failed because the
destination host was down. This is recorded when the camera server is
down (Normally, 10060 occurs).
10065
A socket operation was attempted to an
unreachable host.
There are no routes to connect to the camera
server (This may also occur when there is a
failure in the network cable connected to the
PC or HUB).