Canon VB-C60 - Manual (Page 26)

1-12
Notes on Operating Environment
Notes on Use with Windows XP
If your Storage Server is installed to the PC on Windows XP SP2 or SP3 and your viewer is installed to another
PC, it is necessary to change your [Windows firewall] settings for Windows XP SP2 or SP3.
* The following setting is not required if you install the Storage Server and Viewer on the same PC.
After installation of the Storage Server:
1. Click [Control Panel] from the Windows [Start] menu to launch the [Control Panel].
2. In [Control Panel], select [Windows Firewall]. If [Windows Firewall] is not shown, select [Security Center] and
then select [Windows Firewall].
3. When the [Windows Firewall] dialog is shown, select the [Exception] tab and then click [Add Port].
4. In the [Add a Port] dialog, enter a name for the Storage Server, e.g., "VK-64/VK-16 Storage Server". And
then enter the Port number as "80". Make sure the TCP protocol is selected and click [OK].
5. In the [Windows Firewall] dialog, your additional Storage Server is now listed. Make sure the check box is
marked. Click [OK] to close the dialog.
Setting is now complete.
Notes on Use with Windows XP/Vista
In cases where you cannot access more than 10 camera servers due to power or network failures, the movie
server's operations or viewer's configuration changes may take time or images may not be viewable including
those on camera servers you can connect to.
Also, if the auto-switch interval is set to 20 seconds or less, images may not be displayed in the viewer.