Canon VB-C60 - Manual (Page 265)

9-23
Messages List
T
rou
b
les
ho
oti
n
g
Camera
Summary
window
The changes you are trying to save cannot
be sent to the storage server (<storage
server name>) and will be lost.
<Communication Error Messages -
Details>
An error occurred while saving the settings
in the Camera Summary window.
Are you sure you want to delete storage
server '<storage server name>'?
An attempt was made to delete a Storage
Server other than the Master Storage
Server.
Are you sure you want to delete location
'<location name>'? An attempt was made to delete the
location.
Are you sure you want to delete zone
'<zone name>'?
An attempt was made to delete the zone.
Are you sure you want to delete camera
server '<camera server name>'? An attempt was made to delete the camera
server.
Do you want to save your configuration
changes?
An attempt was made to close the [Camera
Summary] window without saving the
changes.
There has been an error saving the
configuration on the Master Storage Server.
An attempt was made to save the settings,
however, saving the Master Storage Server
settings failed.
Connect to
Master
Storage
Server dialog,
Connection
Error dialog
The master storage server host name is
invalid. Please specify a valid host name or
IP address.
An attempt was made to connect with an
invalid host name/IP address.
The master storage server port is invalid.
Please specify a value between 1 and
65535.
An attempt was made to connect with an
invalid port number.
Edit Camera
Server dialog
Proceeding will delete any schedules
associated with the following : <camera
server name>.
Click Yes to proceed, No to reconsider.
[OK] was pressed in the [Edit Camera
Server] dialog when a change was made to
the camera registered in the camera server.
Event Search
dialog
There are no events to display
No events to be displayed in Event Search
were found.
Extract Video
dialog
The length of the extracted video may not
exceed 1 hour. An attempt was made to configure the time
using a value longer than 1 hour.
Could not save video because there was
no data to record. The recorded video at the specified time
cannot be read.
Failed to extract the video after
<hh>:<nn>:<ss> because two or more
MPEG-4 tracks are included in the selected
time period. You attempted to use [Extract Video] to
save recorded video for a time range that
spans two or more MPEG-4 recording
schedules.
Folder Name
dialog
You must enter a non blank name. Please
check your settings and try again. An attempt was made to add a layout
folder without entering the name.
Messages Cause