Canon VB-C60 - Manual (Page 277)

9-35
Messages List
T
rou
b
les
ho
oti
n
g
Connection error to the camera server
Error (on)/ok (off)
Connection to host <camera server address> : <port> <status>
Continuing recording Recording continuing
Changing the recording frame rate
Effective recording rate (<recording rate before change>

<recording rate after change> %)
Recording rate is the ratio of received images that are actually
being recorded. If the rate is 100%, then all received images are
recorded. If 50%, 1 frame per 2 frames is recorded.
Error Number: Error Description Cause
10048: Address in use
A socket for the communication could not be generated because
a large number of TCP connections are used in the PC.
10050: Network down
The network is down (when a failure occurs in a HUB or router
located near the PC).
10051: Network unreachable A failure occurred in a HUB or router near the camera server.
10054: Forced disconnection from
camera
The TCP connection is disconnected because the camera server
was restarted or another cause.
10060: Connection timeout
A timeout occurred in the TCP connection with the camera server
(This occurs when the camera server is down).
10061: Camera connection refused
The camera server rejected the TCP connection (This occurs
when the port number specification is incorrect or another
cause).
10064: Camera power off The camera server is down (Normally, 10060 occurs).
10065: Camera unreachable
There are no routes to connect to the camera server (This may
also occur when there is a failure in the network cable connected
to the PC or HUB).
10091: Network board not ready There is a failure on the PC network board.
11001: Host not found The host name in DNS could not be resolved.
11004: Host not found
The host name in DNS could not be resolved (11004 may occur
instead of 11001 in 2003).
Empty character string Other Winsock Errors
HT401: Authentication required
The user authentication or password for connecting to the
camera server is incorrect. Check to ensure that it is not an on/off
event.
HT403: Host/IP address restricted
Cannot connect due to the IP address restriction on the camera
server side.
HT502: Bad Gateway 502
The proxy server returns an HTTP 502 error (which occurs when
the proxy server receives an error from the upper proxy).
HT503: Service unavailable 503
The proxy server returned an HTTP 503 error (which occurs when
the proxy server failed to connect to the camera server).
HT504: Gateway Timeout 504
The proxy server returned an HTTP 504 error (which occurs when
the proxy server could not receive a reply from the upper proxy).
Event type Displayed Messages