HP Integrated Lights-Out - Manual (Page 66)

Configuring iLO 2 66
3. When prompted during POST, press the F8 key to enter iLO 2 RBSU.
4. Select Network>NIC>TCP/IP, and press the Enter key.
5. In the Network Configuration menu, toggle the Network Interface Adapter Field to ON by pressing
the space bar.
6. Press the F10 key to save the configuration.
7. Select File>Exit, and press the Enter key.
After iLO 2 resets, the iLO 2 Dedicated Management NIC port is active.
To re-enable the iLO 2 Dedicated Management NIC using iLO 2 interface:
1. Open a browser and navigate to the iLO 2 IP address or DNS name
2. On the Network Settings page, select Enabled for the iLO 2 NIC.
3. Click Apply. A warning dialog appears.
4. Click Yes, and then OK.
After iLO 2 resets, the iLO 2 Dedicated Management NIC is active. When using IRC through iLO 2
Dedicated Management NIC port and depending on the network traffic, you might not have sufficient
time to press the RBSU keys during POST.
DHCP/DNS Settings
The iLO 2 DHCP/DNS Settings page displays DHCP/DNS configuration information for iLO 2. All users
can view the DHCP/DNS settings, but you must have the Configure iLO 2 Settings privilege to change
them. These settings can also be changed using the iLO 2 RBSU (F8 during POST). To access DHCP/DNS
settings, click Administration>Network>DHCP/DNS. The DHCP/DNS Settings page appears.
The following options are available:
• DHCP allows you to select static IP (disabled) or enable the use of a DHCP server to obtain an IP
address for the iLO 2 subsystem.