Axis Communications CD E100 - Manual (Page 14)

Section 2: Installing the StorPoint CD
14 AXIS StorPoint CD E100 User’s Manual
Methods for Setting
the IP Address
You can set the IP address using one of these methods, depending on your
network operating environment:
Note:
❏ When the IP address has been successfully assigned to your StorPoint CD,
you can set the ProtectIP parameter to
on
in order to avoid accidental or
malicious changing of the IP address. With this configuration, the StorPoint
CD will no longer accept a new IP address using the Web browser or ARP
method. You will find the ProtectIP parameter under the [IP] section in the
config.ini file located in the System/ServerProperties folder. Use a
text editor to edit the file.
Web Browser In most Windows environments, you can use a standard Web browser, e.g. Internet
Explorer or Netscape Navigator, to set the IP address.
Follow these steps:
1. Start your Web browser.
2. In the location/address field, enter the following:
Note:
❏ On a Class C network, you can enter simply
where <xxxxxx> are the last six digits of the StorPoint CD serial number
and <ip4> is the last group of the desired IP address.
Method Network environments See ...
Web browser * Windows 95/98/2000/ME and NT page 14
AXIS IP Installer * Windows 95/98/2000/ME and NT, NetWare page 93
ARP *
Windows 95/98/2000/ME and NT, NetWare page 16
UNIX, OS/2 page 17
DHCP Windows NT, NetWare, UNIX, Macintosh page 18
BOOTP UNIX page 19
RARP * UNIX page 19
Text editor Macintosh page 20
*) These methods operate on single network segments only, i.e. they cannot be used
over routers.
<ip3_ ip4> the last two groups of
the desired IP address, e.g. 253_80
for the IP address 192.16.253.80 <nnnnnn> are the last six digits of
the serial number, e.g. 3E5207 for
the serial number 00408C3E5207
<xxxxxx>_<ip4>