Axis Communications CD E100 - Manual (Page 151)

Appendix D: Tower and Drive Installation
AXIS StorPoint CD E100 User’s Manual 151
4. Fix the StorPoint CD with the four screws supplied. Use the upper or lower
holes depending on type of tower and mounting.
Caution!
❏ The length of the screws must not exceed 0.2 inch (5 mm). If they do, the
internal components of the StorPoint CD may be damaged.
5. Attach the power cord to the StorPoint CD. The power supply connector is
a standard PC 4-pin power supply connector (12 and 5 V DC). Hence, the
power supply available in the tower can also be used to supply the StorPoint
CD.
6. Connect the external network connector board to the StorPoint CD using the
shielded CAT 5 cable.
Important!
❏ It is not possible to connect an RJ-45 cable directly between the back of the
StorPoint CD server unit and the hub.
7. Mount the board on the back of the tower. The mounting plate on the board
fits into the standard Centronics cut-out available on most towers.
8. Attach the product label to the back of the tower.