HP MPX200 Multifunction Router - Manual (Page 105)

MPX200 <1> (miguser) #> scrub_lun rm
Job Type Status Job Description
ID
--- ---- ------------------------ -------------------------------------
0 Scrubbi.. Running (Pass: 1 23%) NETAPP LUN-3:VPG1:001
nl Please select a Job Id from the list above ('q' to quit): 0
Do you wish to continue with the operation(yes/no)? [No] yes
nl
Job marked for removal. It will be removed after pending operations are
complete.
The following example shows the scrub_lun rm_peer command:
nl
MPX200 <2> (miguser) #> scrub_lun rm_peer
nl
Job Type Status Job Description
ID
--- ---- ------------------------ -------------------------------------
0 Scrubbi.. Running (Pass: 1 34%) NETAPP LUN-3:VPG1:001
Please select a Job Id from the list above ('q' to quit): 0
Do you wish to continue with the operation(yes/no)? [No] yes
All attribute values for that have been changed will now be saved.
The following example shows the scrub_lun start command:
nl
MPX200 <1> (miguser) #> scrub_lun start
nl
Job Type Status Job Description
ID
--- ---- ------------------------ -------------------------------------
0 Scrubbi.. Stopped NETAPP LUN-3:VPG1:001
Please select a Job Id from the list above ('q' to quit): 0
Start Time for JobId 0:(1=Now, 2=Delayed, 3=JobSerialScheduling) [Now ]
All attribute values for that have been changed will now be saved.
The following example shows the scrub_lun stop command:
nl MPX200 <1> (miguser) #> scrub_lun stop
nl
Job Type Status Job Description
ID
--- ---- ------------------------ -------------------------------------
0 Scrubbi.. Running (Pass: 1 1%) NETAPP LUN-3:VPG1:001
Please select a Job Id from the list above ('q' to quit): 0
Stopping the job. Job will be stopped after pending operations are complete.
set
Configures arrays, system notifications, FC ports, license keys, system operational mode, and
VPGs.
Authority
admin or miguser
Syntax
set
Keywords
Sets the target type of an array to make it behave as either a source, a destination, or
both. For more information, see
“set array” (page 106) .
array
Sets the system notification on or off, and specifies the URL to notify. For more information,
see
“set event_notification” (page 109) .
event_notification
Sets the port status and programmed connection status. For more information, see “set fc”
(page 109) .
fc
Saves and activates the array’s data migration license key. For more information, see “set
features” (page 110) .
features
Sets iSCSI port parameters including IP address, window scaling, and bandwidth. iscsi
Commands 105