HP MPX200 Multifunction Router - Manual (Page 130)

Data Scrubbing Array based licenses issued 20
Data Scrubbing Array based licenses used 20
Available Data Scrubbing Array based licenses 0
show perf
Displays the performance (in bytes) of the active job.
Authority
guest
Syntax
show perf
Examples
The following examples show the show perf command:
MPX200 <1> #> show perf
WARNING: Valid data is only displayed for port(s) that are not
associated with any configured FCIP routes.
Port Bytes/s Bytes/s Bytes/s Bytes/s Bytes/s
Number (init_r) (init_w) (tgt_r) (tgt_w) (total)
------ -------- -------- -------- -------- --------
GE1 0 0 0 0 0
GE2 0 0 0 0 0
FC1 23M 0 0 0 23M
FC2 0 23M 0 0 23M
nl
The following example shows 10GbE ports, where all of the ports are connected:
nl
nl MPX200 <1> #> show perf
WARNING: Valid data is only displayed for port(s) that are not
associated with any configured FCIP routes.
Port Bytes/s Bytes/s Bytes/s Bytes/s Bytes/s
Number (init_r) (init_w) (tgt_r) (tgt_w) (total)
------ -------- -------- -------- -------- --------
GE1 0 0 0 0 0
GE2 0 0 0 0 0
10GE1 0 0 0 0 0
10GE2 0 0 0 0 0
FC1 0 0 0 0 0
FC2 0 0 0 0 0
show perf byte
Displays the active job performance in bytes.
Authority
guest
Syntax
show perf byte
Examples
The following examples illustrates the show perf byte command:
nl
MPX200 <1> #> show perf byte
WARNING: Valid data is only displayed for port(s) that are not
associated with any configured FCIP routes.
nl Displaying bytes/sec (total)... (Press any key to stop display)
nl
130 Command line interface