HP MPX200 Multifunction Router - Manual (Page 109)

MPX200 <1> (miguser) #> set array
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index WWPN, PortId Symbolic Name Target Type
----- --------------------------------- --------------- -----------
0 50:00:1f:e1:50:0a:e1:4c, 01-2b-00 HP HSV200-0 Unknown
1 50:00:1f:e1:50:0a:37:18, 01-24-00 HP HSV210-1 Unknown
2 50:06:01:69:41:e0:18:94, 01-2d-00 DGC RAID-2 Unknown
3 20:70:00:c0:ff:d5:9a:05, 01-0f-ef HP MSA2012fc-3 Unknown
nl
Please select a Target Id from the list above ('q' to quit): 1
nl
Symbolic Name (Max = 128 characters) [HP HSV210-1]
Target Type (1=SrcTarget, 2=DstTarget, 3=Src+Dest Target) [3 ] 1
Bandwidth for Migration (0=Array Bandwidth, 50-1600 MBps ) [0 ]
Do you want to apply array license (yes/no) [No ]yes
All attribute values for that have been changed will now be saved.
All attribute values for Port 2 that have been changed will now be saved.
set event_notification
Sets the system notification on or off, and specifies the URL to notify.
Authority
admin
Syntax
set event_notification
Examples
The following example shows the set event notification command:
nl
MPX200 <2> (admin) #> set event_notification
nl
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
nl
Notification (0=Enable, 1=Disable) [Disabled ] 0
Notification Method (1=HTTP) [HTTP ]
URL [ ]
http://172.35.14.183/put.php
nl
All attribute values that have been changed will now be saved.
set fc
Sets the FC port status and programmed connection status.
Authority
admin
Syntax
set fc
Examples
The following example shows the set fc command:
nl
MPX200 <1> (admin) #> set fc
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
Commands 109