HP MPX200 Multifunction Router - Manual (Page 111)

Authority
admin
Syntax
set iscsi [ <PORT_NUM>]
Keywords
The number of the iSCSI port to be configured. <PORT_NUM>
Examples
The following example shows the set iscsi command:
MPX200 <1> (admin) #> set iscsi 1
nl
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key
to do so.
nl
WARNING: The following command might cause a loss of connections to both ports.
nl
Configuring iSCSI Port: 1
---------------------------
Port Status (0=Enable, 1=Disable) [Enabled ]
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]
Window Size (Min=8192B, Max=16777216B) [32768 ]
IPv4 Address [0.0.0.0 ] 172.35.10.10
IPv4 Subnet Mask [0.0.0.0 ] 255.255.255.0
IPv4 Gateway Address [0.0.0.0 ] 172.35.10.1
IPv4 TCP Port No. (Min=1024, Max=65535) [3260 ]
IPv4 VLAN (0=Enable, 1=Disable) [Disabled ]
IPv6 Address 1 [:: ]
IPv6 Address 2 [:: ]
IPv6 Default Router [:: ]
IPv6 TCP Port No. (Min=1024, Max=65535) [3260 ]
IPv6 VLAN (0=Enable, 1=Disable) [Disabled ]
iSCSI Header Digests (0=Enable, 1=Disable) [Disabled ]
iSCSI Data Digests (0=Enable, 1=Disable) [Disabled ]
Bandwidth, MB/sec (Min=1, Max=125) [125 ]
nl All attribute values for Port 1 that have been changed will now be saved.
set system
Sets system properties.
Authority
admin
Syntax
set system
Examples
The following example shows the set system command:
MPX200 <1> (admin) #> set system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
nl
System Symbolic Name (Max = 64 characters) [Blade-2 ]
Target Presentation Mode (0=Auto, 1=Manual) [Auto ]
Lun Mapping (0=Enable, 1=Disable) [Enabled ]
Controller Lun AutoMap (0=Enable, 1=Disable) [Disabled ]
Target Access Control (0=Enable, 1=Disable) [Enabled ]
Telnet (0=Enable, 1=Disable) [Enabled ]
SSH (0=Enable, 1=Disable) [Enabled ]
FTP (0=Enable, 1=Disable) [Enabled ]
Commands 111