HP MPX200 Multifunction Router - Manual (Page 161)

Table 22 Configuring multipathing on Citrix XenServer (continued)
Removing second direct path from
controller port (for example, Port
B) 1. From the FC switch, zone out the second direct path.
2. In the left pane, click Hardware HBA virtual disk storage.
3. In the right pane, select the Storage tab.
4. On the Storage page, select the LUN, and then click Rescan.
5. Select the General tab, and then on the General page, check the multiple paths.
Adding router path for the
removed controller port (for
example, Port B) 1. Add the second router path by zoning the presented target and host ports.
2. To check the newly added path, rescan the LUN as in 4 .
1
These validations use the method described in “Zoning in presented targets: Method 1” on page 5-13. Alternatively,
you can use the method described in “Zoning in presented targets: Method 2” .
Citrix XenServer multipath configuration 161