HP MPX200 Multifunction Router - Manual (Page 42)

Table 7 Online data migration process flow (continued)
For more information, see… Activity Category
“Removing an offline array” (page 69) 17. Remove arrays from persistence.
“Viewing data migration and scrubbing license
usage” (page 39) 18. Check license usage.
Table 8 Offline data migration process flow
For more information, see… Activity Category
Data Migration Service for MPX200 Planning
Guide 1. Plan for data migration. Pre-migration
“Viewing system and data migration job logs”
(page 63) 2. At the start of the project, clear the migration
logs.
“Installing a data migration license key” (page
37)
and “Applying an array-based license to a
specific array” (page 37)
3. Verify the pre-installed data migration license
or install a license key, then apply the
array-based license key, if an array-based
migration license will be consumed for this
project. Otherwise, a per-TB license is used
automatically.
“Configuring the fabric” (page 42) 4. Configure the FC fabric.
“Presenting LUNs to the MPX200” (page 43) 5. Provide the MPX200 access to LUNs from
source and destination arrays.
“Setting array properties” (page 53) 6. Discover arrays and set array properties.
“Job failover and failback” (page 23) 7. Configure automatic failover for high
availability.
“Creating a data migration job group” (page
55) 8. Define user groups.
“Using the data migration wizard” (page 55) 9. Configure and validate data migration jobs. Configure
migration jobs
“Data migration configuration” (page 11) 10. Ensure that the server no longer has access
to source LUNs. Migrate and
monitor
“Starting serial scheduled jobs” (page 60) 11. For data migration jobs that are scheduled
for a delayed start, specify the start time for the
job.
“Viewing job details and controlling job actions”
(page 62) 12.Monitor data migration jobs.
“Acknowledging a data migration job” (page
67) 13. Acknowledge the data migration jobs.
“Viewing system and data migration job logs”
(page 63) 14. Export data migration logs.
“Removing an offline array” (page 69) 15. Remove arrays from persistence.
“Viewing data migration and scrubbing license
usage” (page 39) 16. Check license usage.
Configuring the fabric
Because MPX200 online data migration presents multiple virtual FC ports to each physical FC port,
enable NPIV support on the FC switches. If the FC switches (older 2 Gb FC switches) do not support
NPIV, or if you do allow the switch to be configured with NPIV support, enable loop mode support
on an FC switch port, then configure the MPX200 FC ports in loop-preferred or loop-only mode.
The default is loop-preferred.
42 Performing data migration