American Fibertek Commander C10e-PoE/C10p-PoE - Manual (Page 27)

27
Logging In/ Logging Out
Using a web browser enter the Commander’s IP address (default IP
address in the case of first login) as the URL and the log in screen
will appear. If the location has been previously titled, that name
will appear. Entering the User Name and Password will define
your access level to the Commander. After entering your user
name and password, press Submit. If a mistake is made, press
Reset and reenter the user name and password.
The Master Admin default username is “Admin”. The Master Admin default password is
“Password”. The Master Admin password should be changed on first login.
Log In Exceeded:
Commander allows three attempts to enter the correct User Name and Password. If on the fourth
attempt the correct name and password are not entered the user will be blocked. Retries can be
attempted after a 5 minute time out period.
When the number of allowable retires is exceeded, the invalid log attempts will be recorded in the
access log showing the date, time and IP address source
Logging Out:
The icon in the upper right hand corner of the screen is used to log out of Commander. Point and
click on the icon to log off. The icon will appear in all operation and programming screens
allowing the log out function at any time.
Auto Logging Out:
If no activity has occurred in twenty (20) minutes, Commander will automatically log out as a
security precaution. To avoid this, after programming is complete, leave Commander operating in
Status View mode with a programmed refresh rate.
As a result of pressing the Log Out icon a pop
up will appear asking if you are sure. Press OK
to log out. Press Cancel to return to the previous
screen.