American Fibertek Commander C10e-PoE/C10p-PoE - Manual (Page 51)

51
Tree View
Tree View shows the status of sensors, alarm inputs and auxiliary outputs. These are referred to
as “Logical Devices”.
Tree View Operations
When first clicking on the Tree View, the
Device ID will appear. In the Tree, Commander
is referred to as the ‘Physical Device” while the
connections to Commander are referred to as
“Logical Devices”
If an operator has previously named
Commander, that name will appear.
Expanding the Tree will show the show the three
logical devices, Probes, Alarms and Aux
(auxiliary)
Expanding each logical device will display its
name, status as indicated by the color,
assignment to an LED and the number of alarms
or warnings that have occurred.
Views: Tree View- Logical Device Status
Sensor Probes: In the example to the right, the
green circle to the left of probe test 03 indicates
it is currently in the normal mode. The (4)
indicates that probe is assigned to front panel
LED number 4. (Although the LED may be
assigned to 1 through 10, Commander only
displays LED #1 in the front panel.) The number
30 indicates that a combination of 30 alarms and
warnings has occurred.
When a name has previously been assigned to a
logical device, the tree will show that name.
When a name has not been assigned it will
automatically be given the probe ID number.
Port Probes: Are displayed under Probes. The
number in ( ) is the port number displayed after
the Port Name. The number following this is the
number of events that will appear in the log
when active.