American Fibertek Commander C10e-PoE/C10p-PoE - Manual (Page 97)

97
Selecting Ingress and Egress Ports
Selecting Ingress and Egress Ports
After the Monitoring port is programmed, select
the Ingress and Egress ports to monitor.
Important Note: Ingress and Egress ports cannot
be the same as the selected monitor port. If this
condition occurs a warning will be issued.
Clicking on Save will issue a pop up asking you
to confirm your selection.
Selecting OK will issue a pop up warning that
the action might result in a disconnect. Press OK
to effect the change.
Selecting Default will allow you to return Port
Monitoring to its default settings.