American Fibertek Commander C10e-PoE/C10p-PoE - Manual (Page 38)

38
IP Settings
Default IP Settings
Commander’s default settings are displayed to the
right. DHCP is set to off in the default settings and the
default HTTP port is 80.
IP Address: 192.168.10.11
Subnet mask: 255.25.255.0
Gateway: 192.168.1.1
HTTP Port
This is the port used to access these setup screens via a
web browser. This setting is restricted to certain ports
as displayed on screen
DHCP
When DHCP is enabled Commander will report any changes in its IP Address to the email
address entered in the Global Settings. (Master Admin function)
DNS
A DNS resolver address is required for SMTP (email) to function. Select Enable and enter at least
one DNS server address.
Port Communications
Port communications is controlled by the switch. See Switch Flow under Switch Setup.
Alert Console IP Address:Port
The Alert Console allows you to program an IP address and port to receive alerts responses to
alarms and warnings. The receiving client computer must allow these alerts to be received. Up to
four addresses and ports may be entered separated by a space.
Network Settings: Saving your settings
Clicking the Save button will result in a pop up
asking you to confirm your settings. Click OK to
confirm. Click Cancel to return to the previous
screen. Remember to make a note of your new
IP Address.
Network Settings: Settings Accepted
When Commander has successfully accepted
your changes it will issue a pop up. Click OK to
continue set up.