American Fibertek Commander C10e-PoE/C10p-PoE - Manual (Page 50)

50
Activating an Auxiliary
Commander allows an operator to manually
activate an auxiliary.
Move the mouse over an auxiliary in the off
position. Left click will bring up an alert box
asking to confirm your decision to active the
auxiliary. OK will result in activation. Cancel
will return the screen to the previous mode.
Once an auxiliary is active it can be de-
activated.
Acknowledgement:
In order for acknowledgement to respond to an
alarm, it must be programmed as part of the
security set up.
AUX operation: If an AUX is active it will
show as red. The user can extinguish the AUX
by point and right click. A pop up box will
appear “Turn Aux (number) off? Yes/No
Operation of Alarm Acknowledgements and the effect on Aux duration operations:
In the case of an sensor warning or alarm the following will occur:
The logical device name will turn Amber in the case of a warning
The logical device name will turn Red in the case of an alarm
This action will continue as long as the condition is valid
If an Auxiliary has been programmed to turn on for a pre-determined period of time, its
logical name representation in the tree will become Red, indication it is active.
An operator with permission will have the ability to terminate the auxiliary output prior
to its programmed time, by the action of moving the mouse over the individual Auxiliary
LED and point and click.
A display block will appear with “Turn aux (number) off? YES/NO.
A YES will De-activate the Auxiliary and return that part of the screen to the tree
display. A NO will return that part of the screen of the tree display.
If YES is selected the following actions will take place:
The auxiliary function will be de-activated and will not become activate again until the
current alarm condition is ended and a new alarm input (programmed to correspond with
that individual auxiliary) is received . The Red indication on that Auxiliary’s logical
name will be terminated and return to its normal non-color state.