American Fibertek Commander C10e-PoE/C10p-PoE - Manual (Page 88)

88
Spanning Tree Protocol
STP / RSTP Setup
In order to use STP or RSTP, the ports
assigned for this purpose must be disabled in
Switch Flow. These disabled ports will then be
available in STP setup. Disabled port names
will appear in Red.
Both STP and RSTP use the same parameter
settings. In almost all cases, the defaults
settings should be used.
Up to four Spanning Tree bridges may be maintained by Commander. Disabled ports are assigned
to any one of the listed bridge numbers using the radio buttons provided.
Text entry boxes are provided in order for the STP
parameters to be set to values other than the default.
After changes are made, click the Save button. A
dialog box will appear asking to “Change STP
Configuration”. Click OK to continue. Another
warning will then appear. Click OK to save.