Remove and replace front panel assembly – Anritsu 373XXA User Manual
Page 127
Equipment Required:
q
Open-end wrench, 1 in.
Preliminary:
q Switch 373XXA power off. Remove the power cord.
q Remove handle assembles and all covers (paragraph 8-3).
Remove/Replace Procedure:
Step 1.
Place the 373XXA in normal (top-side up) position.
Step 2.
Remove the four corner screws and the top center screw
that secure the front panel assembly to the chassis (see
Figure 8-6).
Step 3.
Place the 373XXA on its top (bottom-side up).
Step 4.
Remove the screw that fastens the front panel casting ex-
tension lip to the Test Set Module tray. (See diagram at
left.)
Step 5.
Using a 1 in. open-end wrench, remove the nuts and wash-
ers that secure the Port 1 and Port 2 couplers/bridges to
the front panel casting.
REMOVE AND REPLACE
FRONT PANEL ASSEMBLY
373XXA MM
8-13
Figure 8-6.
Removal of Front Panel Assembly