Anritsu 373XXA - Manual (Page 63)

Step 2. Press the Utility Menu key ( System State key group) to dis-
play the UTILITY FUNCTIONS OPTIONS menu. From
menu, select GENERAL DISK UTILITIES (see below).
Step 3. If FLOPPY DISK UTILITIES menu appears, select
HARD DISK UTILITIES.
Step 4. From HARD DISK UTILITIES menu, select FORMAT
HARD DISK.
Step 5. After formatting is complete, reload System Software from
the master floppy diskettes. Retry boot-up. If fail, contact
ANRITSU Customer Service Center.
Hard Disk Problem 2 If system does not bootup from hard disk and floppy disk:
Step 1. When the five initializing messages are displayed after
power on, press any key within 2 seconds.
Step 2. Follow the instruction on the display to format the hard
drive. After formatting is complete, reinstall system soft-
ware from the master floppy diskettes. Retry boot-up.
Step 3. If fails, replace the A16 Hard Disk PCB; reinstall system
software from the master floppy diskettes.
Step 4. Retry boot-up. If fail, contact ANRITSU Customer Service
Center.
Floppy Disk Problems If a floppy disk problem is indicated during bootup from floppy disk but
the system is able to bootup from the hard disk:
Step 1. Ensure the floppy disk media is in good condition
Step 2. Verify disk drive connection at Motherboard connector J2.
Step 3. Retry boot-up. If fail, replace the A13 - I/O#1 PCB.
TROUBLESHOOTING SYSTEM DOES NOT BOOT-UP
373XXA MM 5-9
SELECT UTILITY
FUNCTION OPTIONS
GPIB ADDRESSES
DISPLAY
INSTRUMENT
STATE PARAMS
GENERAL
DISK UTILITIES
CALIBRATION
COMPONENT
UTILITIES
l
l
PRESS <ENTER> TO
SELECT
FLOPPY DISK
UTILITIES
DISPLAY
DIRECTORY
DELETE FILES
COPY FILES
TO HARD DISK
FORMAT
FLOPPY DISK
HARD DISK
UTILITIES
PRESS <ENTER> TO
SELECT
HARD DISK
UTILITIES
DISPLAY
DIRECTORY
DELETE FILES
COPY FILES
TO HARD DISK
FORMAT
HARD DISK
FLOPPY DISK
UTILITIES
PRESS <ENTER> TO
SELECT