Sony DAR-RD100 - Manual (Page 99)

99 GB
O
the
r Op
erat
io
ns
* When selecting the TV’s two-digit programme
position, press -/-- and then the number buttons. Hold
down the TV button for the whole time.
To operate the TV/DVD button
(for SCART connections only)
The t TV/DVD button switches between the
recorder and the last input source selected on the
TV. Point your remote at the recorder when using
this button. When you connect the recorder to the
TV via the SCART jacks, the input source for the
TV is set to the recorder automatically when you
turn the power on. To watch another source, Hold
down TV and press
t TV/DVD to switch the
TV’s input source.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the one
that works with your TV.
If you have a Sony DVD player or
more than one Sony DVD recorder
If the supplied remote interferes with your other
Sony DVD recorder or player, set the command
mode number for this recorder and the supplied
remote to one that differs from the other Sony
DVD recorder or player.
1
Turn off the recorder.
2
Hold down x (stop) on the recorder until
“MODE” appears in the front panel
display.
3
While pressing x (stop), repeatedly press
. / > on the recorder to select the
command mode (MODE 1, 2, or 3).
4
While pressing DVD " / 1 on the remote,
press the number buttons to set the same
command mode for the remote as you
selected above.
2 +/– Adjusts the volume of your
TV
t TV/DVD Switches your TV’s input
source
PROG +/– Selects the programme
position on a Sony TV
Number buttons and
-/--* Selects the programme
position on a Sony TV
Manufacturer Code number
Sony 01 (default)
Grundig 04
Hitachi 06
Panasonic 05, 12
Philips 02, 03
Samsung 13
Sanyo 07
Sharp 08
Thomson 11
Toshiba 10
JVC 09
Command mode Enter
“MODE 1” 01
“MODE 2” 02
“MODE 3” (default) 03
x
. / >
Front panel display
1 2 3
4 6
7 8 9
0
5
Number buttons
DVD " / 1