Adaptec ANA-62000 - Manual (Page 111)

9-5
Duralink64 Standard Driver for NetWare
Configuring the Ports
After installing the Duralink64 Standard driver, use the following
steps to configure the ports.
1 In the Main Menu, select Configure Ports, and then press Enter.
Figure 9-4. Duralink64 Standard Setup Main Menu
2 In the Ports screen, make sure you know which port names are
assigned to the actual ports on the NIC.
Figure 9-5. The port names (Adptsf1, Adptsf2, etc.) do not correspond to the
physical PCI slot numbers on the motherboard.
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default) Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled 1 Adptsf1
2 Adptsf2
3 Adptsf3
4 Adptsf4
5 Adptsf5
6 Adptsf6
7 Adptsf7
8 Adptsf8
No. Port Name NIC Connection Type Status
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]