Adaptec ANA-62000 - Manual (Page 112)

9-6
DuraLAN Fast Ethernet NICs User’s Guide
3 O PTIONAL . The Autodetect (default) detects which device the port is
connected to and negotiates the port speed and transmission mode
accordingly. Autodetect
is recommended; however, to change
the connection type(s):
a Select the port, and then press Enter. (To select multiple
ports, select the port, and then press F5 one at a time.)
b In the Type of Connection menu, select the type, and then
press Enter. (Connection Types on page A-2 provides
descriptions.)
Figure 9-6. Type of Connection Menu
4 O PTIONAL . Enabled is the default status. To disable a port,
select the port, and then press Tab.
5 Press Esc when you are done.
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default) Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled 1 Adptsf1
2 Adptsf2
3 Adptsf3
4 Adptsf4
5 Adptsf5
6 Adptsf6
7 Adptsf7
8 Adptsf8
No. Port Name NIC Connection Type Status
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]
Autodetect (default)
10 Mbps/Half Duplex
10 Mbps/Full Duplex
100 Mbps/Half Duplex
100 Mbps/Full Duplex
Type of Connection